AWSBDB - Scribner messages
This section lists error and warning scribner messages that might be issued.
The message component code is BDB.
AWSBDB001E
Error opening connection to conman, Error !1
AWSBDB002E
Error unable to create stdlist
AWSBDB004W
The timeout value !1 is not valid. The default value has been used.
You have supplied a timeout value that is not in the correct format. It must be the numeric value of the number of seconds required for the timeout to be used by scribner. For example, the value for 30 seconds must be 30, not 30s or 30 secs.
scribner uses its default timeout value.
If you want to apply a timeout value different from the default, shut down the scribner process and rerun the scribner command, supplying a correctly formatted timeout value.
AWSBDB005E
There is a syntax error. Too few parameters have been supplied.
The scribner process requires the link parameters to be passed to it. These parameters have not been supplied correctly.
The scribner process cannot start.
Rerun the scribner command, supplying the correct linking parameters.
AWSBDB006E
Error in ntoh (Symphony rec): !1
AWSBDB007E
Error sending scribner_response rec: !1
AWSBDB008E
Error receiving scribner_response rec: !1
AWSBDB009E
Error: Could not allocate storage for comarea
AWSBDB011E
Error reading stdlist file for job !1.!2: !3
AWSBDB012E
Error opening stdlist file for job !1.!2: !3
AWSBDB013E
Error getting stdlist file status information for job !1.!2: !3
AWSBDB014E
Error closing stdlist file for job !1.!2: !3