Verifying configuration of existing IBM i Domino servers

IBM® Sametime® provides which TCP/IP addresses are currently being used by your Domino® servers.

About this task

If you do not have any Domino servers configured on your system, you can skip this section.

To determine which TCP/IP addresses are currently being used by your Domino servers, follow these steps after verifying that you have started your Domino servers.

Procedure

  1. From an IBM i command interface, sign on to your server.
  2. Verify the current TCP/IP addresses for each Domino server by entering the following command: WRKDOMCSL server_name
  3. From the Domino Console display, type the following command and press Enter: sh port tcpip
  4. Press F5 to refresh the screen.
    • If the server is using only one TCP/IP address, you will see a specific TCP/IP Local Address listed using port 1352. For example, 10.1.2.3:1352.
    • If the server is using all active TCP/IP addresses, you will see *:1352 displayed as the Local Address rather than a particular TCP/IP address.
  5. Record the results for each Domino server, as you will use this information later.