1102 - U0003

1102

Undefined feedback from VTAM, or a serious error after a VTAM request that makes continued processing impossible. (Note: Message EQQV015E is issued only if request parameter list (RPL) feedback is available.)

If an undefined feedback code was returned by VTAM, this is a VTAM problem. Contact the Software Support.

See message EQQV015E, which precedes this abend, for diagnostic information. Message EQQV015E is issued only if request parameter list (RPL) feedback is available.

1103

VTAM has detected an error while processing a request, or VTAM has detected an error in an associated session, task, or address space.

Contact the Software Support.

None

1104

Serious error opening the network communication function (NCF) ACB. The VTAM definition of the NCF application is in probably in error.

If the diagnosis points to a user definition error, correct the error and restart the subsystem. Otherwise, contact the Software Support.

See message EQQV027E, which precedes this abend, for diagnostic information.

1110

Unrecoverable error when scheduling a VTAM macro.

Contact the Software Support.

See message EQQV015E, which precedes this abend, for diagnostic information. Message EQQV015E is issued only if request parameter list (RPL) feedback is available.

1111

Invalid SCB block, or invalid pointer to it. (Internal NCF error.)

Contact the Software Support.

None.

1112

Invalid NAB block, or invalid pointer to it. (Internal NCF error.)

Contact the Software Support.

None.

1113

Invalid BIB block, or invalid pointer to it. (Internal NCF error.)

Contact the Software Support.

None.

1121

All entries in the node table have been used. (Internal NCF error.)

Contact the Software Support.

None.

1124

Invalid action code. (Internal NCF error.)

Contact the Software Support.

None.

2001

Problem accessing the special resource data space during daily planning, and the VALEACTION keyword of BATCHOPT specifies ABEND.

Take a copy of the old current-plan file, the EQQCXDS file, and the EQQRDDS file, and contact the Software Support.

None.

3900

Not enough storage available to continue execution.

Make sure that the region size specified for the tracker system meets HCL Workload Automation for Z requirements. Region size requirements are documented in and in IBM® Workload Scheduler for z/OS®: Program Directory. If your region size is too small, enlarge it accordingly, and restart the system. Otherwise, contact the Software Support.

None.

3999

HCL Workload Automation for Z' internal validity checking has discovered an error condition (internal HCL Workload Automation for Z error). A message that contains the reason for the abend, as well as other debugging information, is written to the HCL Workload Automation for Z diagnostic file, EQQDUMP.

Contact the Software Support.

None.

U0001

The EQQSWAUP program abends because the Sysin | input file could not be opened.

Contact the Software Support.

None.

U0002

The EQQSWAUP program abends because the Sysin input file contains more than 256 records.

Change the Sysin input file so that it contains at least 256 records and rerun the program, otherwise, Contact the Software Support.

None.

U0003

The EQQSWAUP program abends because the Sysin file references a step that does not exist in the job or because nested procedures were used in the JCL.

Change the Sysin input file to delete references to steps that are not in the job or to change nested procedures, otherwise Contact the Software Support.

Check the Sysin input file for steps that do not exist in the job or for nested procedures. Nested procedures are not supported.