If you select an existing job in the Unload Job
Select window, the Command Line text
box shows the onpload command that ipload generated
for that unload job.
The following figure shows the Command Line portion
of an Unload Job Select window. The Command
Line text box displays the onpload command
generated for the job shown in The Active Job window. Figure 1: Fragment of the Unload
Job Select window
The command line, onpload -p testum -j testum2_out -fu,
contains the following arguments.
-p testum
The project where the job is stored.
-j testum2_out
The name of the job.
-fu
The job that unloads (rather than loads) data.
You can copy the onpload command from the Command
Line text box and paste it at a system prompt to run the
unload job. If you need to run the unload job multiple times (for
example, every evening at 5:00 p.m.), you can save the onpload command
and run it later.
You do not need to start ipload to run a job
from the system prompt. Both ipload and onpload use
the onpload database, but each one uses it independently.