Once you have set the servers to start automatically and
configured the task schedulers, validate that the configuration is
correct by restarting the servers on which the IBM Docs components
are installed.
About this task
Repeat these steps for each server on which an IBM Docs component
is installed.
Procedure
- Restart the operating systems.
- After the reboot is completed, confirm that the servers
and task schedulers are running.
- If the servers and task schedulers are not running, verify
that you have completed the initial configuration steps in the Post
Installation tasks section.
Note:
- You do not have to start the servers by order.
- Webserver Restart Setting provides the No as
the default configuration value. By default, webserver must be restarted
manually after finishing deployment before verifying deployment result.
In actual product environment, the webserver is being used for other
areas. In order to avoid negative impacts to users, the admin will
determine when the webserver will be restarted to enable the configurations
and changes of IBM Docs to
work. If without the negative impacts, admin can change the default
value to Yes, then, the deployment scripts
will restart webserver automatically.
- IBM Connections Restart Setting provides the No as
the default configuration value. By default, Connections must be restarted
manually after finishing deployment before verifying deployment result.
In actual product environment, the Connections is being used for other
areas. In order to avoid negative impacts to users, the admin will
determine when the Connections will be restarted to enable the configurations
and changes of IBM Docs to
work. If without the negative impacts, admin can change the default
value to Yes, then, the deployment scripts
will restart Connections automatically.