After the reports are installed and configured, you must test the configuration before
you enable authentication. You can test the configuration by running a sample of
reports.
Before you begin
Verify that Unica is running and that the
Cognos® BI service is running.
About this task
To test your configuration before you enable authentication, complete the following steps.
Procedure
-
Log in to Unica as a user with
application access.
-
Create data so that the reports have something to show.
- Open Cognos Connection.
-
Browse to the report folders you imported and click the link to a basic report.
For example, for Unica Campaign, select .
- Click a link in the report.
- Log in to the Unica application
as a user with application access and browse to the Analysis page.
When you specify the URL for the Unica application,
be sure to use a fully qualified host name with your company domain
(and subdomain, if appropriate). For example:
http://serverX.ABCompany.com:7001/unica
- Click the link to the same report that you tested in Cognos.
If you cannot view the report, it is likely that the IBM
Cognos firewall is not configured correctly. See Configuring IBM Cognos Application Firewall for Unica.
Note: If you cannot view an Unica Deliver report,
verify that the Unica Deliver stored procedures
were run.
- Click a link in the report.
- Open an individual item, click the Analysis tab,
and verify that the report is correct.